Learn · fixing to walls
How to hang a cabinet or mirror with a French cleat
A French cleat is one strip of board cut lengthways at 45°. One half goes on the wall with its slope facing up, the other on the back of the cabinet facing down, and the weight pulls them tight together. It holds heavy things, spreads the load along the wall, and lifts off again when you need it to.
Step 1 of 5
How a French cleat works
The two halves hook together on the 45° cut. The half on the wall has its slope facing up and in towards the wall; the half on the cabinet has its slope facing down. As the weight pushes down, the slope pulls the cabinet in against the wall: the heavier it is, the tighter it sits.
What you need
- 18 mm plywoodA strip about 100 mm wide, a little shorter than the cabinet
- A saw that tilts to 45°The track saw I use, or a table sawThe one I use: Festool TSC 55 KEB Track Sawon Amazon
- Wood glue and screwsTo glue and screw the half on the cabinet
- Wall fixings for your wallPlugs for brick, screws into studsHow to fix to your wall
- Spirit levelThe one I use: Stabila Spirit Levelon Amazon
- Impact driverThe one I use: DeWalt Impact Driveron Amazon
Links marked Amazon are affiliate links: I earn a small commission if you buy through them, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Be careful
- The cleat is only as strong as its fixings into the wall: a screw into every stud it crosses, or plugs into brick, never plastic plugs in plasterboard.
- Check where the cables and pipes run before you drill.
- Two people to lift a heavy cabinet or mirror on and off.
Questions
How much weight can a French cleat hold?
As much as its fixings into the wall can hold. The cleat spreads the load along its length, so it’s the screws that decide: into studs or brick, with a fixing in every stud, it holds wall cupboards and big mirrors.
Plywood or MDF for a French cleat?
Plywood. Screws hold better in it and its sloping edge doesn’t crumble. 18 mm is plenty for cabinets and mirrors.
Does the cleat show?
No: it sits behind the cabinet. The spacer at the bottom keeps the cabinet straight, so from the front it looks screwed to the wall.
Can I use one for shelves or tools?
Yes. Run a few wall halves along a wall and anything with a cabinet half on its back hangs on them, and moves along when you want it somewhere else.
Can you fit it for me?
Yes. I build and fit cabinets, shelves and fitted furniture across London. Press Get a quote, or send me a photo of the wall on WhatsApp.
Rather I do it?
I fit cabinets, shelves, panelling and fitted furniture across London, fixed properly into whatever your walls are. Tell me about the room and I’ll come and measure up for a free quote.