Learn · fitted furniture
How a fitted wardrobe is built, step by step
A fitted wardrobe is built as square boxes on a level base frame, then joined to the room: side panels scribed to the walls, a plinth along the floor and a top panel up to the ceiling. Check the floor and the walls first. No room is level or square, and the wardrobe has to be.
Step 1 of 10
Check the floor is level
Lay a long spirit level on the floor where the wardrobe will stand. Lift the low end until the bubble sits in the middle and measure the gap under it. That gap, and where the highest point of the floor is, tell you how the base has to be set.
Check front to back as well as side to side.
What you need
- Long spirit levelFor the floor, the walls and every unitThe one I use: Stabila Spirit Levelon Amazon
- Laser levelA level line across the whole roomThe one I use: DeWalt Laser Levelon Amazon
- Tape measureThe one I use: Stanley FatMax Tape Measure 5mon Amazon
- Track sawStraight, clean cuts in boardThe one I use: Festool TSC 55 KEB Track Sawon Amazon
- JigsawCuts the scribed line on a side panelThe one I use: DeWalt Cordless Jigsawon Amazon
- Impact driverThe one I use: DeWalt Impact Driveron Amazon
- School compassFor scribing panels to the walls
- Hinge jig and a 35 mm bitDrills the hinge holes to a set depth
- 18 mm board, hinges, runners, rail and shelf pins
- A cut list for your sizesI can draw it and send every part’s sizeHow to fix to your wall
- Plan the wardrobe in 3D firstMy free wardrobe plannerHow to fix to your wall
Links marked Amazon are affiliate links: I earn a small commission if you buy through them, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.
Be careful
- Boards are heavy. Two people to stand a tall unit up, and check it clears the ceiling as it tips up before you build it.
- Check for cables and pipes before you screw a unit to the wall.
- Fix every unit to the wall so it cannot tip forward when the doors and drawers are open.
Questions
Why not build it straight onto the floor and walls?
Because the room isn’t straight. Doors and drawers only hang and run properly in a box that is square and level. So the boxes are built square, stood on a base frame levelled with spacers, and the side panels, plinth and top panel take up whatever the room is doing.
How do I know a unit is square?
Measure it corner to corner, both ways. If the two diagonals are the same, it is square. If not, push the long corner in until they match, then fix the back on.
How big a gap should I leave at the walls?
Enough for a side panel you can scribe: I allow at least 20 mm at each wall. Too tight and there is nothing to cut back when the wall leans.
What board is a fitted wardrobe made from?
I build in 18 mm board, backs included: MDF where it will be painted by your decorator, or birch plywood, oak or walnut where the wood shows.
Can you build it for me?
Yes. Fitted wardrobes are most of what I build, across London. You see it in 3D before anything is cut. Press Get a quote, or send me a photo of the space on WhatsApp.
Rather I do it?
I fit cabinets, shelves, panelling and fitted furniture across London, fixed properly into whatever your walls are. Tell me about the room and I’ll come and measure up for a free quote.